puch grimeca sealed wheel bearing conversion kit - SNOWFLAKE - REAR
puch grimeca sealed wheel bearing conversion kit - SNOWFLAKE - REAR
 



  $48.99


qty:



here's what ya get in this PARTYYY!:

 
 
COMPLETE sealed bearing conversion kit for your puch grimeca snowflake rear wheel! RAD!

be sure to measure the diameter of the area where the bearing cup is pressed into the hub!! the bearing OD is 30mm and ID is 12mm

comes with:
-(2) 16101 sealed wheel bearings
-(1) 190mm axle w/ spacers

FAG = unparalleled bearing quality!!

you also get a couple extra 12mm washers too just for the hell of it!

installation tip! remember that most wheels use 11mm axles, so grab a 12mm drill bit to drill out your brake plate to accommodate the larger 12mm axle you'll now be using.

check out the second photo above! that's the order that things should go down. the aluminum spacer goes in da middle, ya dig!?



taco rating taco rating 4 of 5 4 of 5 Total Reviews: 8 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Give a 1 star review if you're a bad mechanic December 26, 2022
taco eater : Goshen Mopeds from Goshen, IN United States  
Because this is a 5 star product and if you can't figure this stuff out, put down the wrench, get out of the hobby and find something less challenging like Pokémon cards.

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 Conversion axle needs to be further threaded... June 20, 2022
taco eater : Jamie Rezendes from Warwick, RI United States  
The conversion to sealed bearings in recommended BUT the product product does not mimic the original axle and the threads do not go in far enough to properly secure the brake plate and bearings. Spacers are offered but are useless because the axle thread doesn't afforded the ability to tighten it all down.
DISAPPOINTED!

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 works very well July 30, 2020
taco eater : Michael Kuriger from Santa Clarita, CA United States  
the only think I'd add is 2 additional nuts so you have a nut on each side of the arm like stock.  otherwise you need to tighten it so tight it can strip that axle threading

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 Missing parts. July 19, 2020
taco eater : Quattro Audi. from Kensington, CT United States  
These wrecked my snowflake mag.. bummer. Spacers are useless. You need something else,  not sure what. Maybe washers?

Make sure nothing is grinding.  Make sure your hub isn't getting HOT.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Xlnt Replacement for my Puch MX II January 13, 2019
taco eater : Fbg from Santa Barbara, CA United States  
Why would you ever grease old bearings with this kit never need to deal with individual bearings race and cup

Was this review helpful to you?

View All Customer Reviews