taco eater :
Frederic Chelminski from HOUSTON, TX United States
I was able to use the long spacer between the two Bearings, but the others were not the right length. This is TOTALLY understandable. The quality of the Spacers was pretty bad too. FYI: you will likely need to obtain a variety of spacers and experiment, or learn how to accurately measure what you will need. You may even need a machinist to make good spacers like I did.
Was this review helpful to you?
0 taco eaters like this review
Center spacer is too short
April 27, 2025
taco eater :
Steve from Lake Mary, FL United States
I bought this for my Puch spoked wheel sealed bearing conversion. However the center spacer is about 1/4 too short causing the bearings to bind when tightened.
Was this review helpful to you?
0 taco eaters like this review
kevin spacey
November 3, 2017
taco eater :
rodney from san francisco, CA
so many spacey spacers it helps when youre setting up a wheel. has a nice squared off end so that you can hold the axle in place instaed of marring the threads when you need to loosen a tricky axle nut or tighten it. used these on tons of bikes, good cheap simple solution.
Was this review helpful to you?
0 taco eaters like this review
bent
March 14, 2017
taco eater :
broke ass hobbit from Riverside, RI United States
axle came bent out of the box. splendid
Was this review helpful to you?
0 taco eaters like this review
Great fit for Peugeot Rear!
January 24, 2015
taco eater :
A.T. from Southampton, MA United States
perfect length for pug rear. snug fit in bearing as well. got one that looks like the threading on one side ran almost into the shaft, so its a little flared and will only go through things from the other end. snug tho!
You are going to need some proper spacers 
kevin spacey 
bent