puch 19mm PHBG piston port intake - ROUND port
puch 19mm PHBG piston port intake - ROUND port
 



  $39.99

 :HERE NOW!!
qty:

 
 
19mm ID intake for most PISTON PORT puch kits out there! of course this is a round port but you can always get it to work with a little bit of work.

this intake can either be used with a clamp style or spigot style PHBG carburetor, you pick!

works great with piston port kits such as the airsal 44mm, airsal 45mm, and piston port treat kit 45mm!

19mm - ID
24mm spigot clamp
40mm mounting eyelets, same as all puch intakes except metrakit 80. fits perfectly on metra 65, metra 80 would need a lil file or dremel time and it can be made to fit!

**may not fit korado/austro daimler frames, haven't checked that.

taco rating 5 of 5 Total Reviews: 5 give your taco rating here

  0 taco eaters like this review
 
works July 4, 2018
taco eater : John Simpson from New Orleans, LA United States  
Clears frame. Mine had a big enough hole in front of the elbow to let light through. Waited too long to send it back and patched it. Look at it good before you bolt on. Glad I did, saved me some issues.

Was this review helpful to you?

  0 taco eaters like this review
 
my favorite intake March 7, 2018
taco eater : michael kuriger from Santa Clarita, CA United States  
used on a square port 70cc athena kit, still flows better than the 90 degree intake.

Was this review helpful to you?

  1 taco eaters like this review
 
best intake for pp puch kits July 6, 2016
taco eater : Will caldwell from san francisco, CA United States  
yup this is the best PHBG intake for puch piston porty kits!! clears maxi frames perfectly

you can use it for clamp or spigot style, i would suggest spigot though because clamp style might get a lil leaky.

you can lightly match the circle to square for even more fun!!

Was this review helpful to you?

  0 taco eaters like this review
 
Kstarred Za50 March 24, 2014
taco eater : kevin bishop from Alpine, TX United States  
This is so much better than my exhaust header intake, buy it! Just match the circle to the square

Was this review helpful to you?

  0 taco eaters like this review
 
Fits Metra 80! July 20, 2013
taco eater : Anonymous Person from Fairfield, CT United States  
Yup, definitely fits a Metra 80 with minimal work to open up the flange holes just a hair, clears a PHBG 19 no problem on a Magnum frame w/E50.  Intake overall needs a bit of cleaning up (casting residue), but while you have the Dremel out anyway ...

Was this review helpful to you?