puch engine bolt party
puch engine bolt party


here's what ya get in this PARTYYY!:

engine mounting hardware party for all puch mopeds!!

comes with 3x of all! just like the original ones!

3x - m8 x 85mm bolts
3x - m8 x 1.25mm nuts (includes nylon lock nuts currently)
3x - m8 flat washer

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
5 of 5 good August 13, 2019
taco eater : Drake Abrahamsson from San Clemente, CA United States  
when I bought my moped it only had 2 bolts! if this is you you should replace them all. I'm glad I did. I had to grind off the ends of 2 of them because they were very close to my chain and I got scared they'd catch or something idk just seemed like a catastrophe waiting to happen. I like the locknuts

Was this review helpful to you?

  0 taco eaters like this review
5 of 5 Personally thoughts October 27, 2016
taco eater : Countryobtunning from Princeton , MA United States  
Man like I'm going to go out on a limb and say use a wave washer and just a normal nut but that's my two cents

Was this review helpful to you?