polini velocity stack for many mikuni carbs - 44mm ID

polini velocity stack for many mikuni carbs - 44mm ID
 



  $29.99

 :HERE NOW!!

qty:

 
 
blue anodized polini velocity stack for the VM20mm round slide, 24mm mikuni flat slide, 28mm mikuni flat slide and vm26 mikuni round slide or any other carbs with 44mm OD filter mounts.

52mm OD where the set screws go, 47mm OD at the dip and 64mm on the OD of the stack...enjoy!

polini 203.1501

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 3 give your taco rating here

  0 taco eaters like this review
 
5 of 5 im blue if i were green i would die April 27, 2015
taco eater : river2strokes from Columbus, OH  
so nice! but mine was missing an inset screw out of the package
darn!

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Suck It, Trebeck February 27, 2015
taco eater : Dingleberry ImmenHoffer from seattle, WA United States  
So yeah this thing is nicely machined and goes on my VM20 just fine.  When I installed this stack it crushed my carb inlet where the 3 set screws were, and somehow the stack still fell off.  I think I'm going to drill 3 holes partway through the carb where the set screws go, and reinstall the stack with locktite so it wont fall off again.  

I ran the bike without an air filter for a while and I had no problems with the carb spitting oil all over the bike, the stack seemed to keep it contained.  My only complaint with this stack is that they anodized it blue, I prefer aluminum, but whatever.

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 STACKED October 12, 2013
taco eater : scott schmidt from kenosha, WI United States  
these suck so hard... ended up throwing 3 of these on my vm24's for a suzuki gt380 triple***

Was this review helpful to you?