|
|
|
|
|
not bad |
May 29, 2014 |
taco eater :
Timmy from TX United States
|
|
This works on the QT-50 BUT it is not ideal. You got to swap out the metal sleeve in the top bushing and you got to use a shock extender. The bottom bolt works fine. IF you run the MLM pipe you got to get that back tire as low as possible while it is on the stand for maximum pipe clearance. My tire is about .25 inches off the ground using this shock and an extender. Note: my frame was bent so I bent it back till I got it where it is. Where yours will end up is up to the geometry of it all. How to tell if a banana shaped frame is bent farther than it should be? Get two or three of them side by side and compare.
Was this review helpful to you?
|
|
|
|
|
|