minarelli V1 brn 3 SHOE / 2 SCREW racing clutch
minarelli brn 3 SHOE racing clutch


 :*sorry none today*


this is the three shoe racing clutch made by BRN for minarelli V1.

these have 2 tension spring adjusting screw for each of the clutch pads. yes 2

make sure this is what ya need, many models out there yeah!

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
5 of 5 this is not the bennasar clutch December 20, 2010
taco eater : frenchie from buenos aires  
this is not bennasar clutch is different and made by brn....

Was this review helpful to you?

  0 taco eaters like this review
3 of 5 Meh. April 29, 2010
taco eater : Angelique (Angel) Sanders from Whiteford, MD United States  
This clutch was not manufactured for the pedal-versions of Minarelli bikes, therefore, the taper of this clutch will have to be machined to fit that of the pedal-version crank.
I have the 2-screw, 3-shoe version. It did have an improved grab, and performed well, but the brass center is a weak component, allowing a set-screw to strip out, and leaving speckles of brass in my transmission oil.

Was this review helpful to you?