taco eater :
MennoOonneM from San Diego, CA United States
Very, very simple to swap this with your stock cylinder and see a healthy improvement.
Consider re-gearing your bike to a lower gearing ratio and adding a Mamba pipe to really unlock the potential of this kit.
Was this review helpful to you?
1 taco eaters like this review
Great kit
May 13, 2012
taco eater :
David Stone from San Diego, CA United States
This is an easy kit to install, just match it with a Mamba pipe and a 16/16 Dellorto and you will be in the 40's. Don't forget to open your intake or get a new one to match the carb.
Was this review helpful to you?
0 taco eaters like this review
A distinct lack of balls
April 1, 2012
taco eater :
Ascoute from the Zeros from toledo, OH United States
This kit is mehhhh I put it on a brass bushing V1 and a needle bearing V1 with no noticeable difference. The porting is nothing to write home about either, however it is a tough kit. Don't expect to see much more then 35mph with poor bottom and low end
Was this review helpful to you?
0 taco eaters like this review
head
September 19, 2011
taco eater :
Anonymous Person from Dayton, OH United States