Go to harbor freight and get the viton o-ring set. Put one on the base of the threads of the petcock and another on the base of the large nut and tighten it down. Seals perfectly and works good.
Was this review helpful to you?
0 taco eaters like this review
Seals is poopy
April 2, 2021
taco eater :
Max Goldberg from Omaha, NE United States
The seal between the petcock and tank is junk. I used 2 orings and got it to seal.
Was this review helpful to you?
0 taco eaters like this review
Decent Petcock, ill fitting gasket
May 29, 2020
taco eater :
Luke Vancraeynest from CT United States
The Petcock is fine so far, but when trying to seat the gasket correctly, there would always be a slight gap between the gasket and the threads of the bolt. I ended up just cutting my own gasket and I'm sure if I had an o-ring set I could've found one that would fit. It's also difficult to properly mount the side covers on a 210 with this petcock. I ended up filing/cutting away some of the plastic to make enough space for it to operate properly without hitting the side cover.