honda hobbit 70cc polini kit

honda hobbit 70cc Polini cylinder kit




polini 70cc 46mm kit for lotsa honda bikes - most 70s honda mopeds/nopeds use the same/similar/interchangable cylinder.

Check first to be sure, but this will fit for sure on HOBBIT CAMINO PX PA50 PA50II EXPRESS NU50 and so on.

cast iron with tons of ports and a lovely dual ring piston, includes, as always all gaskets rings piston n such to get ya going

some of these may require a lil fin cutting to clear some oil drain or something but it is no prob.

fits easily for sure on hobbits and PA 50s

polini part number 119.0030

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 11 give your taco rating here

  1 taco eaters like this review
5 of 5 Great Kit June 25, 2019
taco eater : Dave from Overland Park, KS United States  
Bolted right on my NC50.  Made my fat butt go fast.

Was this review helpful to you?

  0 taco eaters like this review
5 of 5 honda hobbit with 70 cc kit and pipe June 14, 2018
taco eater : Richard Grzeszak from Grandville, MI United States  
what jeting are you all useing on this setup with stock carb ??????????? main jet and low speed jet ?????

Was this review helpful to you?

  1 taco eaters like this review
5 of 5 easy install, faster than traffic. April 29, 2017
taco eater : James B from Minnetonka, MN United States  
just installed it on an nu50 with the 25$ gy6 clutch that "bolts onto nu50, Amazing!". bought the red molassi springs but after research decided to keep stock (for now) took about an hour to install the cylinder, another hour for the clutch, an hour for venting the clutch case and putting on new tires and brakes. moped rips. and i think if i use the drill bit that was provided with the kit to bore the carb jet ill get even more speed. also running a custom exhaust with the stock nu50 header going to a puch bi-turbo pipe. works with the rear fender.

Was this review helpful to you?

  5 taco eaters like this review
5 of 5 An inappropriate ammount of power November 1, 2016
taco eater : Boiler3 from minneapolis, MN United States  
just got his strapped onto my NC50 express. for  anyone wondering if it will fit, yes, yes it will. no cutting, no drilling, just bolt it on and go.

good clear instructions for newbs like myself, piston rings already installed, all gaskets included, even a drill to bore out your main jet if you have a stock carburetor. (kit recommends 88 on a PHBG for those with aftermarket carbs)

and yes, Inappropriate amounts of power.

Was this review helpful to you?

  1 taco eaters like this review
5 of 5 My favorite kit March 22, 2012
taco eater : jason kluczyk from chicago, IL United States  
Over the malossi or parma option.  Yes, the athena is better, but this bolt and go!  Or rebuild and case match!  Plenty of power and this this kit is a tank.  I paired it with a weakends pipe, tm24, super stuffy crank and tjt, and it rips pretty hard.

Was this review helpful to you?

View All Customer Reviews