taco eater :
I like to go fast while not going fast from Princeton, MA United States
I bought like 3 of these…..I got one on a hobbit, one on a set of maxi/magnum long Ebrs
The Hobbit I welded new tabs on the forks
Maxi long Ebrs no mods needed
They work, keeps my forks straights
Was this review helpful to you?
0 taco eaters like this review
decent as a template for your own
April 28, 2022
taco eater :
Unky Grubb from FARMINGTON, NH United States
i grabbed two of these thinking they looked similar to stock puch/EBR puch stock like braces, but the brackets sit about a half in. too wide, i cut the silly booger welds off, mounted the brackets to the fork, added small plates to make the bracket arms longer, moved the stabilizer closer to the forks-on the inside of the brackets and rewelded. was able to hack up the other one to use the brackets to make a second custom.
long story short, not for Puch- but it you want some nice project stock it welded decently, and the price is right
Was this review helpful to you?
0 taco eaters like this review
hmm
August 31, 2011
taco eater :
alex boyd from pa
looks like it converts the stupid fender/stabilizer on earlier bikes to use a standalone stabilizer...
might get one
Was this review helpful to you?
1 taco eaters like this review
EBRs
April 8, 2011
taco eater :
kevin whritenour from McGraw, NY United States
works like a charm on my puch maxi EBRs.
Was this review helpful to you?
0 taco eaters like this review
I'd get one if I didn't already have one.
February 8, 2011
taco eater :
Sean L. from Tucson, AZ
Looks a lot like it would fit a JC Penny Pinto. Measurements are pretty close. If it's anywhere as good as the original part, it'll hold your fender on pretty well.
Work like a charm ( kinda ) 
decent as a template for your own