taco eater :
Hunter Skiff from Boca Raton, FL United States
Have this installed on my '78 NC50. Of note this part no longer comes with the nipple for the oil injection. To remedy this I drilled the intake, pressed the factory brass oil feed barb into place, and braised it to the intake. Works perfect!!! Intake quality it top notch and everything works as it should, including brake and fender mounts. Very impressed with the quality of this and other MLM products!
Was this review helpful to you?
0 taco eaters like this review
does NOT work with express sr
December 1, 2017
taco eater :
KW from KCMO
Good quality intake, but the intake hole on the reed cage is in the wrong spot. half the hole is covered up by the reed cage.
Was this review helpful to you?
0 taco eaters like this review
Great Product
September 22, 2017
taco eater :
Barry Hart from Valdosta, GA United States
Perfect! This thing is the best available. I didn't have any problems with the brake cable or mounting. It was super easy to replace. The Mikuni carb adds a lot of low end torque and the moped idles like a dream!
Was this review helpful to you?
0 taco eaters like this review
wow
September 3, 2017
taco eater :
Jacob Wine from Mequon, WI
it's great! no surprise here, MLM quality is evident. rear brake cable holder thing works fine, and so does the fender mount. get it now!
Was this review helpful to you?
1 taco eaters like this review
rear brake cable holder is a bad design
January 30, 2017
taco eater :
jay brooks from Pittsboro, NC United States
The rear brake cable holder has no sink hole to cradle the outer casing of the brake cable. So the raw naked cable and the outer casing does sides through the holder and doesn't allow tension to kick crank start.