Return to MLM honda express intake with fender mounts - VM20
 :
page of 1


  1 taco eaters like this review
 
1 of 5 Super disappointed with this one Saturday, July 10, 2021
taco eater : Anonymous Person from Coon Rapids, MN United States  
So there are a few glaring problems with this intake. Despite being for a bigger carb, the intake pipe is tiny! Problem number 2, it didn’t work with my VM20! The chunk on the float bowl for draining the gas hits on the transmission cover! I’ll make it work, but super disappointed nevertheless. My bike is a 1980 Honda NC50

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Works great! Saturday, October 27, 2018
taco eater : Hunter Skiff from Boca Raton, FL United States  
Have this installed on my '78 NC50. Of note this part no longer comes with the nipple for the oil injection. To remedy this I drilled the intake, pressed the factory brass oil feed barb into place, and braised it to the intake. Works perfect!!! Intake quality it top notch and everything works as it should, including brake and fender mounts. Very impressed with the quality of this and other MLM products!

Was this review helpful to you?

  0 taco eaters like this review
 
2 of 5 does NOT work with express sr Friday, December 1, 2017
taco eater : KW from KCMO  
Good quality intake, but the intake hole on the reed cage is in the wrong spot. half the hole is covered up by the reed cage.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Great Product Friday, September 22, 2017
taco eater : Barry Hart from Valdosta, GA United States  
Perfect! This thing is the best available. I didn't have any problems with the brake cable or mounting. It was super easy to replace. The Mikuni carb adds a lot of low end torque and the moped idles like a dream!

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 wow Sunday, September 3, 2017
taco eater : Jacob Wine from Mequon, WI  
it's great! no surprise here, MLM quality is evident. rear brake cable holder thing works fine, and so does the fender mount. get it now!

Was this review helpful to you?

  1 taco eaters like this review
 
2 of 5 rear brake cable holder is a bad design Monday, January 30, 2017
taco eater : jay brooks from Pittsboro, NC United States  
The rear brake cable holder has no sink hole to cradle the outer casing of the brake cable. So the raw naked cable and the outer casing does sides through the holder and doesn't allow tension to kick crank start.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Perfect! Sunday, August 14, 2016
taco eater : Jordan Williams from Aurora, CO United States  
Finally an intake for my VM20. Loads more power than stock and even has a little hose inlet that I use for a boost bottle. Turns out the terrible carb with auto choke setup on this little old engine was the problem all along, now it flies! 35MPH on a stock '81 NC50 all day long.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Zooooom Zoooom Friday, March 4, 2016
taco eater : Andrew Johnson from Carrollton, KY United States  
This thing coupled with a 20mm carb and boyseen reeds puts the zoom zoom in my boom boom. My little express has MAD low end torque now and a smidge more top end.

Was this review helpful to you?