tomos dellorto SHA 15mm straight intake
tomos dellorto SHA 15mm straight intake
 
  $22.00

 :HERE NOW!!
qty:

 
 
straight shot 15mm intake for tomos A35 mopeds like sprint and targa

use also with puch applications of the tomos alukiteeeee for SHA perfection

also the intake originally for super tom!

tomos part number 223603

taco rating 3.5 of 5 Total Reviews: 5 give your taco rating here

  0 taco eaters like this review
 
just do this April 30, 2014
taco eater : david miller from newark, OH United States  
just replace the top piece from your old carb,and grid down your motor mount holes a few mm.thats what I did with my 1993 golden bullet.

Was this review helpful to you?

  1 taco eaters like this review
 
Needs hacking, but works. May 28, 2013
taco eater : Skipper from Philadelphia, PA United States  
I had to take about 3/4 of an inch off the intake, but my SHA 15.15 is sitting comfortably on my 02 TargaLX. I had to re-use the top from the stock carb for clearance, and still had to trim some of the ridge on the bottom of the frame tank. so the throttle cable would clear completely.

You will have to drop the motor and exhaust to jet, so be aware.

It comes with a 68 jet

Was this review helpful to you?

  1 taco eaters like this review
 
does the job ok August 18, 2012
taco eater : Tri-ped Dave from Woburn, MA United States  
This has the expected tight fit under the tank. I used this on my Bullet/Pryer trike with a 15.15 and she just barely squeezes in there. Remember you have to pivot the motor down to change jets, so not for the lazy, but the performance is there. Straight shot type always delivers the best performance.

Was this review helpful to you?

  0 taco eaters like this review
 
ehh...... May 18, 2011
taco eater : Anonymous Person  
if you bought this thinking you were gonna upgrade to a 15.15 or so, think again. there is NO room to put that carb on as this intake is just a wee bit farked. however, if your clever like me, and you have a top tank, you can just drill a hole above the cable guide in the frame, and run the cable through. looks clean, works great, and ya get your carb. score.

Was this review helpful to you?

  2 taco eaters like this review
 
A bit much May 19, 2010
taco eater : rjimmy from Goleta, CA  
Worked with 14.12 but required removing the exhaust and dropping the engine to change jets...be warned.
oh yeahs...16.16 with this intake didn't fit under the chassis of my 04 Sprint.

Was this review helpful to you?