Return to tomos dellorto SHA 15mm straight intake
 :
page of 1


  0 taco eaters like this review
 
5 of 5 Intake! Wednesday, May 13, 2026
taco eater : Alan from Washington, DC United States  
I actually slotted the bottom holes for fitment. EZPZ lazyboy. Put on Colibri. Moves the carb like 1-2mm more forward vs stock so i can pull the air filter off with almost less cussing. Neat little part with no visible weld around the important parts. works good.

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 'fits' hobbit Friday, November 13, 2020
taco eater : AlexDangerrr from Sioux falls, SD United States  
Drilled some holes and cut off the excess from the mounting flange and shortened the pipe length and bolted it to my stock hobbit intake (opened to 15mm) for that ez breezy 15sha. More work than the moby intake, sure, but it's a straight shot baby

*edit* forgot to say, gotta cut back that airbox!

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 just do this Wednesday, April 30, 2014
taco eater : david miller from newark, OH United States  
just replace the top piece from your old carb,and grid down your motor mount holes a few mm.thats what I did with my 1993 golden bullet.

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 Needs hacking, but works. Tuesday, May 28, 2013
taco eater : Skipper from Philadelphia, PA United States  
I had to take about 3/4 of an inch off the intake, but my SHA 15.15 is sitting comfortably on my 02 TargaLX. I had to re-use the top from the stock carb for clearance, and still had to trim some of the ridge on the bottom of the frame tank. so the throttle cable would clear completely.

You will have to drop the motor and exhaust to jet, so be aware.

It comes with a 68 jet

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 does the job ok Saturday, August 18, 2012
taco eater : Tri-ped Dave from Woburn, MA United States  
This has the expected tight fit under the tank. I used this on my Bullet/Pryer trike with a 15.15 and she just barely squeezes in there. Remember you have to pivot the motor down to change jets, so not for the lazy, but the performance is there. Straight shot type always delivers the best performance.

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 ehh...... Wednesday, May 18, 2011
taco eater : Anonymous Person  
if you bought this thinking you were gonna upgrade to a 15.15 or so, think again. there is NO room to put that carb on as this intake is just a wee bit farked. however, if your clever like me, and you have a top tank, you can just drill a hole above the cable guide in the frame, and run the cable through. looks clean, works great, and ya get your carb. score.

Was this review helpful to you?

  2 taco eaters like this review
 
3 of 5 A bit much Wednesday, May 19, 2010
taco eater : rjimmy from Goleta, CA  
Worked with 14.12 but required removing the exhaust and dropping the engine to change jets...be warned.
oh yeahs...16.16 with this intake didn't fit under the chassis of my 04 Sprint.

Was this review helpful to you?