tomos A55 18mm micro 90 intake PARTY
tomos A55 18mm micro 90 intake PARTY
 
  $58.99

qty:



here's what ya get in this PARTYYY!:
 
 
NEW cnc aluminum 18mm intake for tomos A55 mopeds for PHVA carburetors!! complete PARTY with 90deg silicone coupler, hose clamps and intake gasket!!

this is designed to work best with this 17.5mm PHVA and connect directly into your existing air box. The 17.5mm PHVA TS does not work with this intake since it has more brass tubes sticking out of the side so use the version in the link (PHVA 17.5mm ED). If you try to use the TS the brass tubes on the side of the carb WILL hit the frame once the intake is installed and you will be very unhappy cause your carb will NOT fit.

of course, the silicone coupler will need to be cut down to size. you have a couple options though!! use the 90 degree portion to tuck your carburetor into the stock location with stock airbox with PHVA, or if you want to use a different air filter or PHBG use one of the straight ends to make it shoot to the side. amazing!!

ID = 18mm
clamp mount OD = 24mm
center to center of mounting holes - 32mm

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Quality noodle May 27, 2022
taco eater : jackerz from napa, CA United States  
Pop this right on your a55 and toss your old intake into a bum camp. I made sure I had the correct angle on the hose and that the hose clamp was in a good out of the way spot before I mounted it to the cylinder. I also used a hex bolt with a washer on the right side and Allen on the left. This is just what worked for me. Also get a bud with tiny hands to help if you can, my xxl mitts made it a tad tricky to install with out a buzzball.

Was this review helpful to you?