tomos MLM 15mm SHA carburetor party pack - A3
tomos 15mm SHA carburetor party pack - A3
 
  $142.00


qty:



here's what ya get in this PARTYYY!:

 
 
for tomos a3 mopeds! stock or with a 70cc kit.

comes with high quality MLM intake, mounting bolts, intake gasket, throttle cable and the reliable and user friendly dellorto 15mm sha carb!

note, this comes with a 12mm ID intake gasket. this is perfectly fine if you are using a stock cylinder, but if you want max performance, you'll want to open up the intake port and gasket to 15mm to match the intake.

***warning you will not be able to run your left side cover without some major trimming.****

replace and upgrade the stock carburetor with the finest of parts!

get jets here! (mid 50s to 60s for stock cylinders is a good place to start)

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Snip running boards, make custom allen key, & GO! December 18, 2023
taco eater : Makis from Pittsburgh, PA United States  
Just installed this kit on my brother's '90 Bullet TS and it is running great.

This kit should probably come with hex head bolts instead of allen keys for the bolts that hold the intake into the block. We had to cut an allen key to be able to tighten them down, because the bend for the intake got in the way. Meanwhile any hex head wrench could have been used.

Other than that you will likely need to trim your running boards or bend the heck out of them. But this is a must buy to get any old A3 biek back in running order and easy to tune with the carb in the open.

Also, Wider pedal arms with wouldn't be a bad idea either my brother had to be careful not to kick the carb.

Was this review helpful to you?