taco eater :
Choosedeath from San Jose, CA United States
Is crap, spring is for trash
Was this review helpful to you?
0 taco eaters like this review
s'aight
October 23, 2018
taco eater :
Anonymous Person
As others have stated you'll need to put it in a vice and bend it to get it to line up right. Or you can do what I did and strip all the fresh parts and put it on your old tensioner arm. Boom. Back to ripping.
Was this review helpful to you?
0 taco eaters like this review
Do not buy this
July 16, 2016
taco eater :
You hate me from Long Beach, CA United States
This thing is over an inch offset. Had to make 2 45 degree bends on the arm to get it to line up. You have been warned! I should have read the reviews before I bought this
Was this review helpful to you?
0 taco eaters like this review
these things are the worst.
May 18, 2016
taco eater :
josh hickman from goshen, IN United States
BUT its all we got really, so bite the bullet and buy it. flip the wheel to the other side, and when you go to tighten it down on the swing arm, hold the arm at the 3 oclock position as you tighten the nut. you will feel it gaining tension. DO NOT OVER TIGHTEN or any number of awful things can happen. it strips out VERY easily, so be careful.
Was this review helpful to you?
0 taco eaters like this review
eh
July 25, 2013
taco eater :
Le Big Tasty from Oakland, CA United States
it had to be flipped and bent to work. you have to tighten the hell out of it to get it to right. and if you tighten it too much the spring falls off. cheap metal. but it works.