puch leleu sealed wheel bearing conversion kit - SPOKE

puch leleu sealed wheel bearing conversion kit - SPOKE - FRONT

$31.98

qty:

here's what ya get in this PARTYYY!:

1 of moped 12mm axle with washers and spacers - 165mm ($17.00 value!)
2 of puch KUSTOM special 29mm sealed wheel bearing ($15.98 value!)

COMPLETE sealed bearing conversion kit for your puch leleu spoked front wheel! RAD!

be sure to measure the diameter of the area where the bearing cup is pressed into the hub because this will work on leleu spoked wheels that have a bearing cup outer diameter of 29mm. this may work for peugeot and moby but bust out the calipers first or else...

comes with:
-(2) 29mm sealed bearings
-(1) 165mm axle w/ spacers

installation tip! use a thin layer of red loctite or loctite bearing retaining compound when installing the bearings. also, remember that most wheels use 11mm axles, so grab a 12mm drill bit to drill out your brake plate to accommodate the larger 12mm axle you'll now be using.

taco rating taco rating 4.5 of 5

4.5 of 5 Total Reviews: 3 give your taco rating here

0 taco eaters like this review

On a roll	November 28, 2021
taco eater : Moped Madman from Murrieta, CA Independent Kingdom of Treatland

A little harder to fit than the rear kit, but after a little drilling and spacing im riding on moped cloud 9

Was this review helpful to you?

0 taco eaters like this review

good but lil bit of bearing issue- figured out	August 20, 2020
taco eater : Arron from Livonia, MI United States

axle gr8, bearings gr8, at first forget to take out bearing cup so the bearing seemed huge.

Whether it is moped stuff or lego sets remember to always read the directions.

Was this review helpful to you?

0 taco eaters like this review

i am a fool	August 13, 2019
taco eater : Drake Abrahamsson from San Clemente, CA United States

had trouble for DAYS with these making my brake disc and wheel bind up. if this is happening to you, do this: put both wide spacers on the speedo side and both thin spacers on the brake side. one on the inside of brake disc/speedo, one on the outside. 4 stars bc Im still salty about my own incompetence
ps I used a drill press to make the 11mm fitted brake discs/speedo 12mm and I recommend you do the same. if you don't have one ask your old guy neighbor he probably does, thats what I did and I made a new friend :))))

Was this review helpful to you?

treatland