puch EBR stock maxi clamp conversion upper yoke - SILVER
stock puch maxi replacement upper yoke, or use this to convert your maxi forks to accept handlebar clamps allowing you to finally put on cafe bars, low rise bars, chopper bars, twisted chrome jammers, broomsticks, wands, wizard staffs, lanesplitters, cafe roasters, bar hoppers...
the holes are threaded m7 x 1.0, like stock puch
works with the
puch handlebar clamps
one piece handlebar clamp
if you drill the holes to m7 or just use really long m6 bolts n nuts, the
ebr hydraulic clamps
work but are m6 so same deal as the previous
basically the center to center of holes is about 30mm x 60mm apart. fork bolt holes are m8 and triple top is about a 26mm hole. has the hole for the cables to all go through like the original.
these also replace the
puch maxi ebr stock maxi forks
rate this moped part
be the first!
all rights reserved!