taco eater :
nikki guess from San Diego, CA United States
noticed these don't fit quite right around the bars. though about grinding off some of the inner clamp material for a better fit... just didn't think long enough ha. needless to say i snapped one right down the center trying to tighten it down flush. may try my luck at brazing the mount back together. may give up and throw the whole maxi in the dump.
Was this review helpful to you?
0 taco eaters like this review
Doesn't fit my EBR's but it looks cool!
August 25, 2023
taco eater :
Alexander Shiu from Bloomington, IN United States
Thought it would fit my Puch Maxi EBR's but not so lucky! Might buy the right fork top to put these on though cuz they would look sweet!
Was this review helpful to you?
0 taco eaters like this review
Cheap and good. Just like beer.
July 22, 2020
taco eater :
Alan from WASHINGTON, DC United States
They dont fit quite right around the bar, but they are solid enough and hold the bars on so that's cool.
Also, these fit Puch Murray forks.
Was this review helpful to you?
0 taco eaters like this review
Looks great, slight fit issue
July 1, 2012
taco eater :
KeystoneKreep1313 from Lancaster, PA United States
Not quite long enough for some reason on my Maxi Sport MkII forks, leaves a little gap between the bottoms of the clamps and the top surface of the fork plate. Not really noticeable unless you look close though.
snapped during install. 
Doesn't fit my EBR's but it looks cool! 
Cheap and good. Just like beer.