taco eater :
Anonymous Person from WILMINGTON, DE United States
Make sure you get all the accessory hardware for this bad boy. Get yourself a rubber mallet too. Use the stock seat post to do some of your hammering. And use Lube for them ball bearings nobody likes dry friction.
Was this review helpful to you?
0 taco eaters like this review
Good stuff
September 8, 2023
taco eater :
Alexander Shiu from Bloomington, IN United States
Look pretty sick! These were replaced from the stock Puch forks. Look like they were built to be reliable!
Was this review helpful to you?
0 taco eaters like this review
FORKS MAN
October 7, 2021
taco eater :
Hudson Mel from thousand oaks, CA United States
these forks are amazing what can I say. For the price 10/10
Was this review helpful to you?
1 taco eaters like this review
Nice forks
May 16, 2020
taco eater :
Big Bad Brother from san jose, CA United States
Nice forks and much better than the stock. If you’re putting them puch you might order the puch “EBR speedometer bracket by PIKE” so you can mount the speedo.
Was this review helpful to you?
5 taco eaters like this review
get the lower race shim
July 26, 2018
taco eater :
squirrel from amish country
As mentioned in other comments, these do not come with a lower bearing race. If you buy a new headset for this like I did, you still need to ORDER THE LOWER RACE SHIM. Or use the old lower race and shim from your stock forks. But if you ask me, you should just get all fresh parts. It isn't that much more $, plus you can damage the oem race and shim trying to remove it from your old forks.
Oh another thing, these do not come with a headset nut! 26mm threading is what you need. I recommend getting the version 3 puch fork nut so it can't bottom out on itself when tightening.
Simple and smooth 
get the lower race shim