motobecane stock variator PIN
motobecane stock variator pin
 
  $3.99

 :HERE NOW!!

qty:

 
 
this is one of 4 pins that are on the motobecane stock variator / clutch unit

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
4 of 5 It will work! January 11, 2023
taco eater : Douglas Mackinnon from Livonia, MI United States  
The OD is too large to fit in the back plate.  OEM is 7.12mm. This guy is too fat at 7.95mm.  Stick the screw end in the chuck of a cordless drill and drag it across a file for several minutes checking your progress often.  
Buy an extra incase you over shrink it.  
Press it in with a deep well socket over the stud.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Saved my starter clutch August 26, 2016
taco eater : Thomas Ream from Garden Grove, CA United States  
It does not fit the hole but I chucked it in the lathe, alright i used a drill press an a dremmel cutting wheel! shaved down the OD and made it fit. Used a arbor press to flare the flange and I am goo to go! Could also be welded but press fit is easier.

Was this review helpful to you?