motobecane AV7 SHA carburetor party
motobecane SHA carburetor party
 
  $109.99


qty:



here's what ya get in this PARTYYY!:

 
 
one dellorto 15.15 SHA cable choke carburetor + one motobecane SHA intake + one throttle cable + one choke cable

and you don't need an air filter cause the SHA comes with one! for added air flow, take out the metal mesh filter element.

get your jets here for tuning. for your reference this setup will usually jet around 57-61 with a stock setup. Of course this greatly depends on your altitude, climate, air leaks, compression, etc!

oh this lil malossi micro bendy helps a ton with the confined space of the moby!

comes with knarps so you can trim the cables down as needed.

party rules

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 11 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Solid solution June 15, 2020
taco eater : river2strokes from Columbus, OH United States  
This is an excellent bolt-on kit for forgetting the stock gurtner

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Goodbye leaky gurtner! August 28, 2018
taco eater : Matt from Fairfield County, CT United States  
Bolted right up with the shorty intake. Jetted with a 58 jet. Cables hooked right up into the carb and had plenty of length to reach the handlebars. Cut the cables back a bit and ran the cables into their original spots. Runs like a charm and no more impossible to get to stop leaking gas, Gurtner! Should have gotten the malossi mini throttle 45 degree cable bendy, but I was able to install without it. Might add it on later. Overall, highly recommended.


Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Really wakes up a stock av7 May 31, 2018
taco eater : Michael Malvo from Kirtland, OH United States  
Face it, yer never going to get that stock pitiful gurtner carb tuned right. Yell feel the difference and stock cables will go right in..

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 The perfect choke cable set up August 21, 2017
taco eater : Countryobtunning from Princeton , MA United States  
http://scootertuning.ca/en/carburettors/5119-choke-lever-polini-chrome-65cm.html

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Gurt-Poo to a Dellorto 15.15 on my 79 V50 MotoB April 22, 2017
taco eater : Keith LaHonta from Walnut Creek, CA United States  
Heck of an upgrade, I'd go with a lever choke to make it easier and less cable. Check your throttle cable end, 90 degree might be tight, went with a 32 degree and angled perfect. Jetted with a 58 and found that there should be a round rubber gasket where manifold meets inside carb. Order the carb gasket kit to get it, best 9 bucks you will spend and you have spares.

Was this review helpful to you?

View All Customer Reviews