puch 50cc hi compression head old style fins
Puch 50cc Hi compression head
 



  $23.00

 :HERE NOW!!

qty:

 
 
puch high compression head for any and all puch mopeds. this is "hi-comp" in comparison to the stock 7 fin "low torque" heads that it was based on, so the "hi torque" 8-fin models will be higher compression than this!

used with great success on polini, malossi, metra (65) and stock

add this to a stock cylinder for increased compression, and a subtle increase in all around power

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 8 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Huge improvement on a Metrakit 65cc!! August 27, 2023
taco eater : Matt from Denver, CO United States  
Much better low end, and gives a huge RPM boost over the stock Hi-Torque on a Puch E50 Metrakit 65cc setup. Plus now all the fins line up perfectly on this kit!! Get one now.

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 This is a low compression head, look elsewhere January 27, 2023
taco eater : jason the mason from Havelock, NC United States  
Either treats sent me a low compression head or this head’s performance is awful/more sluggish that stock. Take off is horrible and peak rpm’s where lower. My Tomos a55 engine responded very poorly to this head, put the stock head back on and it zipped to 44 mph like normal. The combustion chamber is 1-2mm deeper on this head with more squish. Stock compression ratio for an A55 is 10:1, so this head must be around 9:1 which is a little higher than a stock Puch 1hp head.
Hey TREATS, the box says Puch 50cc head type II. If that’s wrong let’s get a return going

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Gave stock engine a bit more power February 1, 2020
taco eater : Maurice Diggs from Fort Worth, TX United States  
I bought this head for my stock e50 engine.I noticed an overall increase in performance, which was awesome! The downside is that it doesn't line up with the stock fins, so it looks a bit off.

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 perfect match for metra 65 January 19, 2016
taco eater : josh hickman from goshen, IN United States  
fins line up perfectly on a mk65

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Did the job! September 13, 2014
taco eater : Josiah McCoy from Lititz, PA United States  
Ran on a non-case matched vintage Athena 42mm/ZA combo. No over-heating issues. Good increase in low and top end over factory head. Worth the buy.

Was this review helpful to you?

View All Customer Reviews