| |
 |
 |
 |
|
Use LOW PROFILE bolts |
October 9, 2025 |
| taco eater :
colby ainsworth from Elk Grove, CA United States
|
|
This is a dope intake. I waited and bugged treats about this. (thanks guys, im sorry for being so persistent about stock)
installed it looks great, quality looks great, appears to be pretty flush, but I would use a new gasket.
I highly recommend using low profile bolts on the case near where the carb bowl (vm20) is near. The stainless cap bolts I used when I rebuilt the motor interfered with the carb bowl. If the intake had like 1 more degree of angle it would clear, but it is that tight. I used a low profile hex bolt and it fit just fine.
Was this review helpful to you? 
|
|
 |
|
 |
|
