vespa polini 43mm 64cc kit - 12pin - no head

vespa polini 43mm kit
 



  $129.00

 :HERE NOW!!
qty:

 
 
polini kit, 43mm giant cylinder. cylinder, piston, two rings, wrist pin, clips, base gasket and stickers

polini cast iron with dual ring piston, insane boost port, 64ccs of raw power for makin 4.5HP at 8400 RPMs!

drop this in your stock case with only port matching to complete. seriously rad, no case boring. bolt and go. i bet you can use your stock head! try it. see if it works.

12mm wrist pin size -that's the size of wrist pin in millimeters.

vespa mopeds - bravo, grande, si, kinetic, tfr - this will fit on any of these!

140.0065/ST

taco rating 3 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
bought two of these December 10, 2015
taco eater : moped man from portland , OR United States  
first one was awesome ports lined up and matched  the second one I think was defective sucked air ports way off had to have cases welded  to get a port match and found there gaskets are prone to leak use a little silicone or make your own out of paper

Was this review helpful to you?

  1 taco eaters like this review
 
All together a good kit April 16, 2010
taco eater : Aaron Miller from Ann Arbor, MI United States  
I have used two of these. one got stolen after I put about 600 miles on it. worked like a charm with no problems ever. The other one seized. Not sure if it was my fault or not. The collar cracked which bent my connecting rod. Killed the whole engine. I don't blame polini. It was the first kit I ever installed. These were both on kinetics by the way.

Was this review helpful to you?