taco eater :
Tony Danza from San Francisco, CA United States
Just built this guy out to a 46 pinasco kit. The crank that comes with it couldnt fully spin, hit in multiple places that I had to dremel out. A lot of surfaces are not smooth finish where fuel is flowing. The spacing for the cylinder that this is made for is completely wrong and I had to spce out the cylinder with almost 3mm of gasket to get 1mm of squish. Also the transfers didnt even match up to the kit its for LOL, no big deal tho just funny. The small case half outside has that big square area on it that made it impossible to fit into a subframe. Had to dremel a lot of it down in multiple areas to get it in a stock ciao subframe.
Basically this thing is just an annoying speed case for way too much money.