vespa piaggio olympia con rod - 12 pin
vespa piaggio olympia con rod - 12 pin
 



  $49.99

 :HERE NOW!!
qty:

 
 
olympia needle bearing con rod for vespa piaggio mopeds. this is the 12pin version.

comes with everything shown - con rod, large end bearing, pin, and spacers - no small end bearing

needs a 12 x 15 x 15 small end needle bearing

center to center of small and large end holes - 86mm
small end ID - 15mm
large end ID - 21mm
width on ends - 9.6mm
con rod bolt length - 32.8mm and 16mm diameter

taco rating 5 of 5 Total Reviews: 2 give your taco rating here

  1 taco eaters like this review
 
Fits like a dream February 18, 2016
taco eater : Ninja from New York, NY  
One of my customers gave me a box of parts within the box was a Vespa crankshaft with a sawallz off connecting rod. So I bought this hoping it would fit an OEM stock Vespa Crankshaft it does, The pin is tight I had to lightly grind it so there was a taper so it would fit down the crank hole. After a 30 ton press I was able to blast the old pin out and install the new one within 20 - 30 minutes. If your connecting rod is shot and the rest of the crank is golden this is the buy you will need to resurrect your crank.

Plus now I have a needle bearing connecting rod, extra oil lubrication means extra blasting which means extra FUN!!

Was this review helpful to you?

  0 taco eaters like this review
 
crank rebuild March 30, 2014
taco eater : moped man from portland, OR United States  
I got two of these  if you rebuild your crank tig weld the drive pin the stock cranks have press fit crank drive shafts that tend to spin  this is not my favorite I REALLY LIKE  TOP RACING  but this fits perfect and is ok quality and is a great improvement over stock

Was this review helpful to you?