taco eater :
josh hickman from goshen, IN United States
takes a bit of work, but this is my favorite replacement for the stock bushing. i feel 200% more confident running a kit on a stock crank when i have one of these bad boys.
Was this review helpful to you?
0 taco eaters like this review
I'm scared
October 20, 2014
taco eater :
Michael Mills from worcester, MA United States
Id is real tight. Reads 11.6 mm on the vern. Gonna have to bore this out but.. Theres oil grooves.. uh... hmm. Got this for a kinetic. Pressed into the rod without much prayer. Had to drill oil holes to match the con rod also.
Pushes in nice and tight on into the con rod after leaving bushing in freezer for 30 min. 12mm wrist pin is not even close to sliding in though. Had to slowly mill out the ID with 320 grit sandpaper wrapped around a wooden dowel till it was close, then finished with 600 till the pin fit square. Took all of Dr. Phil and half of Peoples court.