universal SINGLE speedo holder - for 60mm speedos
universal SINGLE speedo holder - for 60mm speedos
 
  $27.99

 :HERE NOW!!

qty:

 
 
super rad universal single speedo holder!! great for custom builds, case racers, etc. plastic housing construction with metal bracket. could just magically bolt on top of your handlebar clamps? very sleek, very minimal

fits 60mm speedometers!! like puch VDO, derbi, tomos, peugeot, minarelli, etc. veglia....even puch tachs are 60mm!

mounting holes are oval approximately 7.6mm x 14mm
mounting pattern is approximately (center to center) 31mm x 59mm
ID of speedo hole = 60.5mm approx

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 3 give your taco rating here

  0 taco eaters like this review
 
4 of 5 Might need to mod August 25, 2023
taco eater : Alexander Shiu from Bloomington, IN United States  
Bought to put on my Puch Maxi, the owner before but EBR forks on it so it didn't fit right. Hand to chop it with a hacksaw, file it, and bend it a bit. May work for yours! Otherwise it holds the speedo good!

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Does the job November 27, 2021
taco eater : Moped Madman from Murrieta, CA  
Cradles my speedometer like a kangaroo mother carries her joey, but ive seen joeys flop out of their mothers marsupium at high speeds, so this might be better as long as your not being pursued by dingos. If thats the case, good luck to ya

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Clean look August 27, 2018
taco eater : Daniel Ramirez from Arlington, VA United States  
Added this to my Tomos LX and really cleaned up the look to make it more cafe racer like.

Was this review helpful to you?