taco eater :
Steve Garn from Creston, NC United States
I.D was 9.7mm, no oil holes. It is not ready to install. Be sure you have a 10mm bit, metal lathe to get I.D correct
Was this review helpful to you?
0 taco eaters like this review
fits, basically.
May 1, 2019
taco eater :
Anonymous Person from minnesota
pressed in perfect, drilled two holes. inner diamater is on the tiiite side. needs drilled and sanded to fit.. also, its brass.
Was this review helpful to you?
0 taco eaters like this review
works
December 10, 2014
taco eater :
eric red from Chicago, IL United States
drilled 2 holes and opened it up a bit. so far so good
Was this review helpful to you?
0 taco eaters like this review
NICE - does not fit motorized bike cranks
May 25, 2013
taco eater :
crayze guy from San Francisco, CA United States
...bought this to try and get rid replace the chanky stock needle bearing in my motorized bike - presses in perfect - BUT wrist pin does not fit uuuuugh - but maybe some sort of drill press will solve the problem