taco eater :
Corey Cooper from Terre Haute, IN United States
I haven’t been able to install in any of my bikes correctly. It’s to right of a fit. Once it’s on it’s really hard to move. Maybe it’s the stuffy part lbvs. But I’ll figure it out sooner or later. But I take it back out and run the stocks. Any ideas
Was this review helpful to you?
0 taco eaters like this review
So far so good
January 20, 2021
taco eater :
WEDETR from Yorktown, VA United States
Freshly installed, working as should. Sight increase in resistance of turn over which should be expected with less volume and more compression. I’ll check back in after some miles 😎
Was this review helpful to you?
1 taco eaters like this review
70cc airsel kit
October 6, 2018
taco eater :
Nothing from Piqua , OH United States
With this stuffed crank work for a55 with 70cc kit?
Was this review helpful to you?
1 taco eaters like this review
best crank for a35
September 22, 2017
taco eater :
Caleb Natal from brooklyn, NY United States
The crank is perfect. And i mean perfect. I poped it in last night runs better than new. If it didnt work for you its couse you didnt put it in right. Press bearing onto crank then heat up case with torch then just slide the crank in case.heat each case side at least 4 min.
Was this review helpful to you?
3 taco eaters like this review
not so perfect
February 22, 2017
taco eater :
Anonymous Person from bristol, CT United States
Put my a35 together to find when I tried to put the clutch bell on their was to much axial clearance behind the bell. Stick to stock cranks
EDIT TREATS : this is not a known issue for this crank. I would imagine you just need to shim it correctly as we have sold a bagobjillion of these over 6 or 7 years with nary a single complaint. Take it apart, check it all out, reshim and find the error as the crank is not the issue.