derbi moped selettra CDI internal rotor ignition system
selettra CDI
 



  $265.00

 :*sorry none today*

qty:

 
 
selettra internal rotor CDI ignition for derbi mopeds....

no lights on this one, for racers only

lotsa fun info here on the puch install !!

"The lit electronic or inner rotor digital (red coil) has been studied, developed by our technical and tested in bank of power with diverse motors, until obtaining the maximum power and the curve of lit that better adapts to all the motors, of small cylinders (especially scooters) achieving the moment of inertia but favorable in all the band of turn exceeding in almost two CV the power obtained with a lit normal.

This comes prepared to function until a state of turn of 27,000 revolutions for minute. We recommend to mount it without keep in mind the chaveta should penetrate it with an advance of 18 degrees of 1.40 millimetres before the upper break-even point (PMS)

This lit can be mounted in any motor, whether with turn in sense of the needles of the clock (right) or with turn contrary sense to the needles of the clock (left), keeping in mind that for the assembly in a motor with turn to right, we will keep in mind you mark them or the rotor, pertaining to the arrow with sense equal to the needles of the clock (right), of the way top coincide marks it but cuts of green colour with it marks unique that is in the stator, all this with the piston in the upper break-even point.

For the assembly in a motor with turn left, will keep in mind you mark them of the rotor that they are next to the arrow that looks in contrary sense to the needles of the clock (left), so that we will return to do to coincide marks it but cuts of green colour with it marks unique that is in the stator, with the piston situated in the upper break-even point. In both cases, the advance indicated with it marks but long of red colour, is the recommended by our technical for this type of motors.

The cable with red case comes prepared to connect it to the button of stopping."

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 1 give your taco rating here

  2 taco eaters like this review
 
4 of 5 UPDATE May 16, 2010
taco eater : cuperteenbro from Cupertino, CA United States  
UPDATE: So after much speculation, we finally attempted to put this on a puch, and we are sad to report it is not an easy bolt on. It could be done, but the issue is in the raised portion on the bottom of the stator as it is larger then the indentation on puch cases. It could be done if you dremmeled the indentation off, but its not easy bolt on, bummer. That said, the bottom of the stator is plastic and easy to size to fit.

this cdi is sweet. easy to set, great construction and probably the coolest ground strap you'll ever find on a moped. This made my derbi/polini go pretty fast. Also can work on puch/others with slight modifications. Only downside is the spark plug wire is glued in and the connections have short wires, so you don't get a whole lot of mounting options.

Was this review helpful to you?