safety kill switch for the race track
safety kill switch for the race track
 
  $18.99

 :*sorry none today*

qty:

 
 
this is a must if you're racing mopeds in france. or if you are stoney. it's a handlebar mounting safety kill switch. you attach the clip on the cord to your glove or race suit so if you fly off your moped it will pull the switch and kill the engine.

taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 3 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Cool idea February 21, 2018
taco eater : Countryobtunning from Princeton , MA United States  
didn't buy yet lol , so can't rate but really cool & funny idea for street use haha. You attach the other end to your jetpack ( top-opening backpack) when you fall off you don't ghost ride the wip. Like a jet ski kill switch or a treed mill lol. This screams racer

So I run this with my main kill switch so when I have two possible kill switches to ground off, i like to remove the harrness & take it with me, it's like a key but way cooler, just look bad ass and poeple think u crazy

Was this review helpful to you?

  1 taco eaters like this review
 
3 of 5 wiring idea October 11, 2011
taco eater : Karl S from Meowyland  
If it's normally open, then rather than running the stator/cdi to the switch to the coil, you could install it like a kill switch in the puch manual. Run the stator/cdi straight into the coil with one leg of this in parallel, and the other leg grounded. When you fall off, the switch becomes closed, and the energy from the stator gets grounded so there is no spark.

Was this review helpful to you?

  3 taco eaters like this review
 
3 of 5 you need to swap the switch September 26, 2011
taco eater : Goose from Detroit  
apparently the switch included is a normal open switch... and most kill circuits need a normal closed.  radioshack has the switch to trade it with

keeps meth heads from riding off on my bikes

Was this review helpful to you?