puch maxi fender HANGER rod device - version 1
puch maxi fender HANGER rod device -  version 1
 
  $5.99

 :HERE NOW!!
qty:

 
 
VERSION 1 !! this is the front fender bracket found on puch maxi fenders. also other puch mopeds too. amazing chrome finish, just like the original!

as you can see, this one differs slightly from the other one we offer ( version 2 ). the two side loops go over the axle unlike the other version!

330mm approx. overall length

taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 4 give your taco rating here

  0 taco eaters like this review
 
5 of 5 My fender be hung like a horse February 9, 2021
taco eater : Scooter Droo from Jacksonville, FL United States  
Used this to mount the treats black square front fender on a 1980 Maxi.  Should mention I'm using the EBR forks as well.  It was stubborn, and I fought with it a bit, but that fender is on there pretty solid, and I get less mud on my face on rainy days.

Was this review helpful to you?

  0 taco eaters like this review
 
2 of 5 Will not fit the maxi MKII original fender... May 14, 2017
taco eater : Bob Selby from Baltimore, MD United States  
I actually ruined it by bending and still totally too long for maxi original chrome fender set-up ...The correct one is aluminum and not as thick and shorter...

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Like NOS! January 30, 2017
taco eater : William S from Baltimore, MD.  
Excellent replacement. The chrome plating is also very nice.

Was this review helpful to you?

  2 taco eaters like this review
 
1 of 5 front fender bracket January 22, 2017
taco eater : chris eichhorn from lancaster, PA United States  
Forget it. Doesn't fit. Tried to rebend. Wrong. No good on late 70's maxi's.

edit treats : these are an exact copy of the stock version. If it will not fit for you then you are using either the wrong fender or forks for this type of fender bracket. email in with photos and we will figure out what the issue is for you!

Was this review helpful to you?