puch maxi chrome EBR crossbar
puch maxi chrome EBR crossbar



EBR crossbar, frame brace, stabilizer, ya, for puch maxi

the bar part with out the bracket is about 19.5"

the threaded part that mounts to the headstock has 2" of thread.

so you screw it out till you achieve crossbar perfection

check your measurements cause even tho they say it's for puch maxi, it might not fit right.

taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 15 give your taco rating here

  0 taco eaters like this review
1 of 5 Doesnt fit. December 16, 2022
taco eater : David Ha from Little Neck, NY United States  
Doesnt fit on my Puch Maxi.

Was this review helpful to you?

  0 taco eaters like this review
2 of 5 should just take puch maxi out of the title July 18, 2014
taco eater : Tony Ngo from largo, FL United States  
This does not fit a puch maxi. Looks like a 6 y/o child welded this thing together and was beaten halfway through. (Single globbed spot weld on 1 side of everything that was welded)  I can make it work but it shouldn't be lable as a puch maxi crossbar.  I aint scurd of a little grinding and welding to make it work though. Sucks i'll have to ruin this blinggy chrome bar I just ordered.

Was this review helpful to you?

  0 taco eaters like this review
4 of 5 Fits hobbit's sorta December 3, 2012
taco eater : Frank Horrigan from Portland, OR United States  
Like everyone says fit hobbit's with some work. Need to widen the headset part I tried smacking onto something the size of my headtube but that's not working. Might use thinner nuts so it mounts better and press the headtube part to fit.

Was this review helpful to you?

  1 taco eaters like this review
3 of 5 Grinder August 29, 2012
taco eater : Rambo from Scituate, MA United States  
Hope you and your grinder and drill bits are friends. You will be seeing a lot of each other. Took some decent modification to work on the stock 78 Maxi.  Had to widen to fit around the neck. Grinned to slide back onto stock frame to clear gas cap. I also threw the supplied nuts away and replaced them with a nylon lock nut.  Had paint chips falling off the bottom of the frame so this was a MUST not for looks. Some time and elbow grease and lots of flying metal fits snug. Can tell the frame is stronger so it works.

Was this review helpful to you?

  1 taco eaters like this review
5 of 5 Fit on '00 Tomos Sprint July 6, 2012
taco eater : Doug Williams from Hilliard, IL United States  
Slight modification, real tight fit. Had to bend the rear flang out and then squeeze it back together.

Pic attached.....


Was this review helpful to you?

View All Customer Reviews