puch moped 25mm chrome exhaust header
puch moped 25mm chrome exhaust header
 
  $19.99

 :HERE NOW!!

qty:

 
 
this is a chrome header for puch mopeds. it's got a whopping 25mm inside diameter. and a 28mm OD for use with 28mm two part chambers.

maxi newport swinger dart daimler pinto magnum freespirit

use your imagination, oooh, the possibilities. . are endless. .

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 5 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Puch treats reed November 14, 2017
taco eater : Countryob from Princeton , MA United States  
This is the exhaust you want, I spent money on what I thought would be a better alround pipe but no luck yet. these pipes make your kit fucking scream, I've been 55mph with 16x38 gearing, with a good tune this pipe can do 60mph with 18x35 gearing. Puch e50 for the Win with a treats reed kit ,19mm phbg & 4 petal.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Snug fit, smooth bend. March 23, 2015
taco eater : Maci Dub from Dubvue, WA United States  
Good fit, Sits pretty close to the flywheel cover on an e50, and far enough outboard to put a chamber where the kickstand and pedals will clear (maxi with a wide za50 pedal shaft).  Bare metal version would be nice but it welded ok after grinding off some chrome.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 yah!.. das is good April 22, 2013
taco eater : Mel Dyer from Simi Valley, CA United States  
If you have a 70 kit like the Airsal with a 25mm I D exhaust port, you need this, (and a chamber) cause your stock header is only like 20mm I D, and is choking your kit! This and the $35 black chamber made my Newport scream like a banshee! unleash that kit!

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Works great with the gigantor chamber March 30, 2013
taco eater : Samuel Drupiewski from El Dorado Hills, CA United States  
Welded this header to one of those uncoated large gigantor robust chambers. I put this on a angled port kit so the flange had to be repositioned. Looks great, sounds great, tastes great!

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 Oh my god... November 21, 2011
taco eater : jiuchan from Japan  
I read somewhere the information that Puch exhaust fit to Sachs 505 too.

But this information is fake.

ID is different and the dimension is different.
Only OD is same 28mm.

So, I asked a factory to make original exhaust straight (cut, cover and weld).

This way is the fastest and reliable...

But, this header is good quarity.
If your moped is Puch and seek some header, I recommend this pipe.

Was this review helpful to you?