puch athena AJH 70cc 45mm reed cylinder kit - complete
puch athena AJH 70cc 45mm reed cylinder kit - complete
 
  $349.99

 :HERE NOW!!

qty:

 
 
athena 70cc 45mm cylinder kit for all puch mopeds! this is the version that includes cylinder, intake, reed block, piston AND a 17mm amal, or animal as we like to call it, carburetor.  this is potentially one of the fastest of the puch 60cc to 70cc cylinders, with some minor mods of course.  as with all great athena kits, guess what? you get metal reeds! yay!  so replace those beasts ASAP, before they kill your dream, or your high.  metal reeds = wet blanket.  the intake on these works great for E50, but for ZA50 bikes the carb might have a bit o trouble fitting in without some mods to the oil injection hump.

taco rating taco rating 3 of 5 3 of 5 Total Reviews: 5 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Set the record straight August 4, 2021
taco eater : Graham Motzing from Eau Claire, WI United States  
I was just cruisin and perusin' before choosin and i noticed this get up has a piss poor rating.

what.

serious blasters know this kit is the absolute business if setup right, even setup wrong it rips pretty hard.  the cylinder spacing is wack, you gotta fix that, space it with gaskets and a countersunk head.  The exhaust port doesn't leave much room so make sure your pipe fits snug.   The reeds are metal and they will break, but you should put big boi VL6 reeds in this anyhow and make your own intake.

I dunno if it really gets 5 stars but 2.5 is pathetic for one of the blastin'est puch kits out there period bar none.

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 garbo May 10, 2020
taco eater : uncle andy LSLB from Medford, MA United States  
just not made good at all

you can't buy one now but if you could you shouldn't

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 awesome kit but August 25, 2012
taco eater : Daughters from Geneva, OH United States  
it doesnt come with screws for the intake soo ya. good luck lookin for those

Was this review helpful to you?

  1 taco eaters like this review
 
2 of 5 Athena 70ccm AJH May 12, 2012
taco eater : Timotej Gradišnik from Bistrica ob Dravi, Maribor Slovenia  
Hello from Slovenia!

I use this Athena Kit on my Tomos - A55 engine - with manual transmission.

One piston ring had some air, so I had to replace the piston. It worked OK, but anyway i replaced it with a piston that has 1 Ring.

The Head of cylinder is OK, but around the sparkplug I have like - liiking of oil from the combustion chamber. The head was new and a new NGK sparkplug, B9HS, B10HS... it's the same. Don't know maybe the bolt hole isn't ok. I always put sparkplugs carefully in and out.

I had to make my own INTAKE, because my Tomos has no room for the stock INTAKE. I have a original Dellorto 21 on it, it runs OK, but have some problem at full throttle - I use a original Dellorto aluminium trumpet.



Was this review helpful to you?

  1 taco eaters like this review
 
3 of 5 rips hard until it blew up, intake sucks October 3, 2010
taco eater : cameron blanchard from worcester, MA United States  
kit blasted 55+ mph until on two different pistons the ring snagged on the same port even after chamfering. low end isnt anythign special, but revvs highhhhhh. the intake is super cheap aluminum and doesnt seal well and the corners tend to snap off. make ur own!

Was this review helpful to you?