puch allstate MS/MV old timer 60cc cylinder kit - 40mm - 12mm wrist pin
puch allstate MS/MV old timer 60cc cylinder kit
 
  $107.00

 :HERE NOW!!

qty:

 
 
60cc 40mm cylinder for oldtimer puch mopeds like the allstate ms50 mv50 and all those other rad ones! be sure to check the photo make sure this is what ya need.

wrist pin size = 12mm

please measure the diameter of your existing wrist pin to verify that you are getting the correct one!

OD of cooling fins = 90mm

dykes ring (L ring) piston even!! score!!! These have a different stroke hence the 40mm equaling 60cc, for all you out there used to the regular length puch stroke. we probably can find some PHBG intakes here that will work on these too if you are interested.

if you need a replacement piston grab one here!!

taco rating taco rating 3 of 5 3 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
1 of 5 it's too big December 4, 2012
taco eater : Anthony from portland, OR United States  
This is the correct bolt patern for an MS 50 but unfourtunatly it does not fit inside of the cooling shroud and it is a 12mm wrist pin where as the MS is a 10mm. so I don't know what it would be good for.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 question May 8, 2012
taco eater : nicholas demauro from chagrin falls, OH United States  
will this work on the 50cc puch sabre

Was this review helpful to you?