🍾 NEW FOR 2019 🍾

the same super stuffy crankshaft for puch e50 that you've known and loved for years has just gotten a major upgrade!! a longer 44mm stroke!!! that's 1mm longer than the stock puch stroke in case ya didn't know.

for guru tuners to take their builds to the next level!! this may require base and head spacing/gasket adjustment to get everything setup perfecto.

very helpful for kits like the treat reed that have a low piston to deck height.

for example, if you are running a 45mm cylinder with a standard 43mm stroke crank, your displacement is 68.38853845987396ccs whereas with the 44mm stroke crank you are bumped up to 69.97896958684777ccs

uses 12x15x15 needle bearing. your kit may be able to accommodate a wider needle bearing like 12x15x16 or 12x15x17.5 if you want to use one, measure to be sure!

taco rating

5 of 5 Total Reviews: 3 give your taco rating here

0 taco eaters like this review

Who would have ever guessed this?!	January 3, 2019
taco eater : Wess Foxx from San Francisco , CA United States

And I just decked my ajh... blahhh! Oh well good job guys.

Was this review helpful to you?

0 taco eaters like this review

More fun to experiment with!!!	January 3, 2019
taco eater : Anonymous Person

Makes 74cc into roughly 76cc yay!! Give that old pooch a new trick!

Was this review helpful to you?

3 taco eaters like this review

ohhhhhfffffffffffuuuuuuuuuuuuuu	January 3, 2019
taco eater : Graham Motzing from Milwaukee, WI United States

kkkkkkkkk

the gods are smiling on puch lovers everywhere, this is just what i need to make the spacing line up on the 'athena/AJH reed clone' bridged port kit with too long stroke!

Was this review helpful to you?

https://www.treatland.tv

🍾 NEW FOR 2019 🍾