puch BASIC center stand party - MAXI - e50
puch BASIC center stand party - MAXI - e50
 
  $45.00
BIG SAVINGS! $39.99


qty:

 
 
this is the center stand pack for puch maxi, newport, cobra, pinto...all that use 8" length stands.

for the e50 one speed engine = uses 3 mounting bolts on bottom!

comes with stand, mounting block with pipe spacer and hardware, and center stand spring!

note if you have larger tires, they might make your bike a tad bit taller so the stand might not be long enough..also could be fine. just keep in mind.

this is how you measure to see if its right for you. get a ruler or measuring tape. make sure both wheels are on a flat floor and go from center of stand hole to floor. should be about 6.5" for this one!



taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 4 give your taco rating here

  0 taco eaters like this review
 
5 of 5 She stands January 14, 2022
taco eater : James from Gunnison, CO United States  
I have a 77 Newport fits and works great.

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 It works but it's stubby June 12, 2021
taco eater : Ron Ridley from Redford, MI United States  
Everything worked fine, however, if you have a Pinto this center stand is about a 1/2 inch shorter than stock. If you have stock size tires you might be okay, but I have 17x2.25 golden boys on mine and you gotta lean on the bars to crank it over. Other than that you gotta sand or work the paint off for it to move easily. Gonna order the magnum stand and try that next.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Yeah, it's what you're looking for. May 19, 2021
taco eater : John Lewis from Louisville , KY United States  
If you have a Puch Maxi and you're missing the center stand: this is what you need. Yes it fits too tightly once installed... grease that shit where it meets the bracket. Work it back and forth until it submits. Now I can kick start this thing without having to peddle down the street.

Was this review helpful to you?

  1 taco eaters like this review
 
1 of 5 Be careful with Chinese crap. August 17, 2019
taco eater : Marrok steel from Bonita, CA United States  
Bolts and spring are nice but the stand itself is crap with varying diameters of the tubing it will not work in the original mounting clamp. Buyers beware

Was this review helpful to you?