|
|
|
|
|
Very cheap but... |
August 5, 2011 |
taco eater :
Anonymous Person from NYC
|
|
So it looked good, snapped together pretty well and seemed ok, until I spent the time pressing the engine cases onto the crank. Once complete, and may I add, looking fantastic, I discovered to my horror, that the bottom right part of the case was poorly machined, and was sitting higher than the left bottom part. The result: zero crank movage. So now after spending an hour heating the case and attempting to remove the case without damaging it so that I can dremel it down to fit my beautiful new crank and work the way it is supposed to, I've put divots and scratches all over the case anyway, and am completely stuck with a beautiful new crank in a crappy new engine case that will not come off. Damn I wish I had spent the extra money on a really nice case. You should do the same, or really really check your case over before pressing it all together. And find the right puller for it, because I don't have one and I'm not happy.
Was this review helpful to you?
|
|
|
|
|
|