polini performance variator for derbi hunter and derbi revolution start 3 & 5

polini performance variator for derbi hunter scooter - 241.570
 
  $99.99

 :*sorry none today*

Free Shipping
qty:

 
 
polini performance variator for the derbi hunter! this also fits derbi revolution motors! both start III and V.

comes with variator, ramp plate, plasic guides, shaft collar + 5.6g weights and 7.7g weights. uses 13 x 16 roller weights

polini part number 241.570

"NEW AND IMPROVED DESIGN ALLOWS PULLEY FACE TO SIT CLOSER AS WELL AS EXTEND FURTHER AWAY FROM THE  RAMP PLATE.  THIS VARIATES YOUR GEAR RATIO EVEN FURTHER GIVING YOU BETTER LOW END POWER WHILE AT THE SAME TIME ALLOWING DRIVE BELT TO RIDE UP HIGHER ONTO THE PULLEY FACE GIVING HIGHER TOP SPEEDS!  INITIAL REPORTS ARE 5+ MPH GAIN!"

"ANOTHER IMPORTANT CONSIDERATION IS THAT SINCE YOUR DRIVE BELT WILL BE RIDING UP HIGHER ON THE PULLEY FACE YOUR ENGINE WON'T BE REVING AS HIGH AT FULL THROTTLE.  THIS "OVERDRIVE" WILL SAVE YOU GAS AND ULTIMATELY EXTEND THE LIFE OF YOUR ENGINE IN THE LONG RUN!"

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
5 of 5 gotta lathe down boss for start 3 Thursday, August 27, 2026
taco eater : Anthony Satariano from San Francisco, CA United States  
ran without the two shims, so you can run wihtout shims or lathe down exact height of shims. shit rips brether

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 derbi revolution Wednesday, April 16, 2014
taco eater : Ryan Nash from Columbia, MO United States  
oh, and this fits the derbi revolution by the way.

edit benji: hehe

Was this review helpful to you?