| |
 |
 |
 |
|
Get yerself some o-rings for this thang |
December 20, 2024 |
| taco eater :
Steven Davis from Jacksonville, FL United States
|
|
Since there are no notes about this that I could find, here's what may help with the o-rings needed for this setup. The larger o-ring on the housing is either exactly 50mm OD or very close (2 inches would be equivalent and a Danco plumbing o-ring #65 is close at 1 7/8". The smaller o-ring in the intake is 38mm (1.5" and a Danco #39 fits if stretched). Have fun carving on a Puch Polini cylinder to get this thing on there!
Was this review helpful to you? 
|
|
 |
|
 |
|
