polini CP 24mm carburetor with pull choke

$229.99

:*sorry none today*

qty:

This was the Polini's great idea, and this is the great result: an innovative carburetor, whose every single component has been designed, developed and manufactured by the company of Bergamo. Available in a wide range of diameters - 15/17.5/19/21/23/24 - it is entirely made of aluminium, it has compact dimensions and it is 40% lighter than a traditional carburetor.

The inlet pipe is very short and it features an exclusive concentric design and a geometry that optimizes the air flows when the gases pass through. The overflow of petrol in the atomizer has been designed to ensure correct flow dynamic at every position of the throttle valve when opens. The hole where the petrol enters and the larger needle allow the constant draft even in the most extreme conditions. The float level, completely made of plastic, and the needle seal are carefully controlled in the production department to ensure the same standard of efficiency over time. These features considerably simplify the setup of the carburetor. Thanks to the extremely sophisticated calibration, the petrol-air flows, main and low jets, have been designed to achieve the best performance with lower consumption. The compact size of the new carburetor is the result of a careful and meticulous management of the inner space and the maximum efficiency of all the components, subjected to strict controls.

To ensure an easy and precise assembly on the best sellers engines and its compatibility to different filter boxes, both originals and racing, flanges with different diameters are available. A prestigious project like this has required a deep synergy of competences in this field. An extraordinary teamwork between the technical and the racing department to reach the goal which is visible to everybody: a technologically advanced product and of absolute reliability.

A further confirmation by Polini which always makes the dreams of who is "racing" inside come true.

100% made in italy!

the polini carburetor weighs 9 oz vs... the PHBG which weighs 16 oz! wowwww!!!

pull choke style

uses - oko/pwk hex main jets

comes with -

112 main jet
40 pilot/idle jet

and -

comes with everything seen here! black metal velocity stack and a 90 degree cable bendy!

grab some idle jets here!!

spigot OD is 28.5mm

air filter spigot ID is 46mm but you can run the 48mm air filters just fine! benji checked!

polini part number 201.2400

taco rating taco rating 5 of 5

5 of 5 Total Reviews: 2 give your taco rating here

0 taco eaters like this review

Excillent	March 17, 2025
taco eater : Andrew Milligan from Windsor, CO United States

I love Treatland.TV and love this carburetor but not as much as I love Treatland.TV, I love treatlan.TV more!!

Was this review helpful to you?

1 taco eaters like this review

Nice replacement for Mikuni 24	July 10, 2022
taco eater : Jason DeFore from Tecumseh, MI United States

I replaced a tired Mikuni 24mm with this. The Mikuni always liked to drip ever so slightly at times from the overflow... about 50/50 chance when parked. I never could get the adjustment right with the float.

I caved and bought the Polini and this was super easy to install and setup. I went with a 115 jet and it's a bit rich for the current summer time, but when it starts to cool off, I think it's going to be perfect.

The adapter was a little of a pain but allowed me to use the stock airbox. That was nice.

Was this review helpful to you?

treatland