polini CP 21mm carburetor with pull choke - clamp style

polini CP 21mm carburetor with pull choke - clamp style
 
  $119.99

 :*sorry none today*

qty:

 
 
This was the Polini's great idea, and this is the great result: an innovative carburetor, whose every single component has been designed, developed and manufactured by the company of Bergamo. Available in a wide range of diameters - 15/17.5/19/21/23 - it is entirely made of aluminium, it has compact dimensions and it is 40% lighter than a traditional carburetor.

The inlet pipe is very short and it features an exclusive concentric design and a geometry that optimizes the air flows when the gases pass through. The overflow of petrol in the atomizer has been designed to ensure correct flow dynamic at every position of the throttle valve when opens. The hole where the petrol enters and the larger needle allow the constant draft even in the most extreme conditions. The float level, completely made of plastic, and the needle seal are carefully controlled in the production department to ensure the same standard of efficiency over time. These features considerably simplify the setup of the carburetor. Thanks to the extremely sophisticated calibration, the petrol-air flows, main and low jets, have been designed to achieve the best performance with lower consumption. The compact size of the new carburetor is the result of a careful and meticulous management of the inner space and the maximum efficiency of all the components, subjected to strict controls.

To ensure an easy and precise assembly on the best sellers engines and its compatibility to different filter boxes, both originals and racing, flanges with different diameters are available. A prestigious project like this has required a deep synergy of competences in this field. An extraordinary teamwork between the technical and the racing department to reach the goal which is visible to everybody: a technologically advanced product and of absolute reliability.

A further confirmation by Polini which always makes the dreams of who is "racing" inside come true.

100% made in italy!

the polini carburetor weighs 9 oz vs... the PHBG which weighs 16 oz! wowwww!!!

pull choke style

uses - oko/pwk hex main jets

comes with -

100 main jet and sometimes 72 main. the number varies!
40 pilot/idle jet but could vary as well

clamp style version that works perfectly on dellorto PHBG intakes!

grab some idle jets here!!

designed to work with peugeot 103 but can be used on pretty much anything you can dream of!

clamp ID - 23mm and uses the same shim as the PHBG!

air filter spigot ID is 46mm but you can run the 48mm air filters just fine! benji checked!

polini part number 201.2102

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
 
4 of 5 Strip this carb and check your jets October 31, 2017
taco eater : just saying from Hamilton, Bermuda  
main was a 72 but they warned us on that one.
pilot had no number on it and was full of brass shavings.
needle  14/22
slide #3 24-30...24mm
atomizer 35-12 all scratched up.

expected better quality from polini...just saying

Was this review helpful to you?