polini CP 17.5mm carburetor with pull choke

polini CP 17.5mm carburetor with pull choke
 



  $114.99

 :HERE NOW!!

qty:

 
 
This was the Polini's great idea, and this is the great result: an innovative carburetor, whose every single component has been designed, developed and manufactured by the company of Bergamo. Available in a wide range of diameters - 15/17.5/19/21/23 - it is entirely made of aluminium, it has compact dimensions and it is 40% lighter than a traditional carburetor.

The inlet pipe is very short and it features an exclusive concentric design and a geometry that optimizes the air flows when the gases pass through. The overflow of petrol in the atomizer has been designed to ensure correct flow dynamic at every position of the throttle valve when opens. The hole where the petrol enters and the larger needle allow the constant draft even in the most extreme conditions. The float level, completely made of plastic, and the needle seal are carefully controlled in the production department to ensure the same standard of efficiency over time. These features considerably simplify the setup of the carburetor. Thanks to the extremely sophisticated calibration, the petrol-air flows, main and low jets, have been designed to achieve the best performance with lower consumption. The compact size of the new carburetor is the result of a careful and meticulous management of the inner space and the maximum efficiency of all the components, subjected to strict controls.

To ensure an easy and precise assembly on the best sellers engines and its compatibility to different filter boxes, both originals and racing, flanges with different diameters are available. A prestigious project like this has required a deep synergy of competences in this field. An extraordinary teamwork between the technical and the racing department to reach the goal which is visible to everybody: a technologically advanced product and of absolute reliability.

A further confirmation by Polini which always makes the dreams of who is "racing" inside come true.

100% made in italy!

the polini carburetor weighs 9 oz vs... the PHBG which weighs 16 oz! wowwww!!!

pull choke style

uses - oko/pwk hex main jets

comes with -

80 main jet
38 pilot/idle jet

grab some idle jets here!!

spigot ID is 25mm which is the same as PHBG rubber couplers!! RAD
air filter spigot ID is 46mm but you can run the 48mm air filters just fine! benji checked!

polini part number 201.1700

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 1 give your taco rating here

  1 taco eaters like this review
 
5 of 5 Super easy to tune April 16, 2016
taco eater : ryan lewis from Long Beach, CA United States  
I guess there were some float issues when these first came to the US. I am guessing Benji and crew swapped them all with good ones cuz I have had no issues, this carb is way more forgiving and tunable than a phbg dellorto. The only negative thing I can say is the needle just needed a c hair more taper, but nothing crazy, this carb is very comparable to a keihin pe, which are found on many two stroke mx bikes. Buy this thing, it's amazing

Was this review helpful to you?