taco eater :
Martin Rodriguez from Oxnard, CA United States
Have a kitaco intake and pkw carb on a 2004 nsr50, the carb had too much angle causing overfill. Used this as a wedge to help level out the carb.
Was this review helpful to you?
0 taco eaters like this review
I planing on buying this spacer & making a copy
January 3, 2018
taco eater :
Countryob from Princeton , MA United States
I need this spacer for my dmp kit because the reed block does not sit correctly in the kit. I'm planning on making copies out of stronger, dense,thicker plastic.
Was this review helpful to you?
0 taco eaters like this review
Well it fit OK but then it cracked easily
April 19, 2015
taco eater :
Dingleberry Immenhoffer from seattle, WA United States
I purchased this thing for my MB5 and it fits great. I sanded down the mating surfaces to attain a better seal. And then when I was tightening down my bolts on install this damn thing cracked. Whatever material it is made out of cannot take much compression force at all. So yah it'll fit your MB5 but I like my gasket bolts tighter than this thing will allow me to go. Maybe its a sales tool cuz I'm buying another one now...
Was this review helpful to you?
0 taco eaters like this review
Surprise!
September 19, 2014
taco eater :
mopedzetc from potomac falls, VA United States
Mine was actually really nice, smooth and level. Fit perfectly on my mb5. No more hitting the case with the vm20
this is the one you want!
Was this review helpful to you?
0 taco eaters like this review
Works but...
May 30, 2011
taco eater :
Max Mojo from Los Angeles, CA United States
It's VERY uneven. Use a sharpening block or even the concrete floor of your garage to flatten it out and get a proper seal!
Carburetor angle 
I planing on buying this spacer & making a copy 
Well it fit OK but then it cracked easily