peugeot polini water cooled 50cc kit

peugeot polini water cooled 50cc kit - 142.0104
 
  $379.99

 :*sorry none today*

qty:

 
 
40.2mm water cooled cylinder without decompression for peugeot mopeds, includes all gaskets, cylinder, head, piston, ring, wrist pin and clips.

radiator and hoses NOT included.

cylinder features W exhaust port and lotsa beautiful transfers

142.0104

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
 
4 of 5 Lots of potential, but watch out for defects! October 23, 2014
taco eater : Michael Antonakakis from Ypsilanti, MI United States  
4 stars, first kit I got was missing about a square cm of Nikasil. Treats took excellent care of me with a good replacement.

-169/118deg (15.1mm/7.65mm)
-center "W" is 1mm or 2mm higher than the outer ends
-all port floors lined up with the piston crown at BDC
-The squish band is tapered a bit, squish is about 2mm at the OD
-transfer port opening at the base of the cylinder is a little bit smaller and rounder than the Polini race case

update 10/23/14:
Kit installed with Doppler pipe and ER3 and clutch pulley. Low end isn't great but doesn't matter now because I can stay in that sweet 10,000rpm power peak. Once above 8000, the pipe hits, and by 8500 it hits HARD and it makes really good power up to 10,500rpm. Lots of blowdown area makes the low end pretty crappy in comparison to the amazing top end. Make sure you have good variator/clutch tuning if you use this kit.

Cruises at 52mph with 220+lb me on stock gearing, and gets up to speed quicker than any moped I've seen.

Was this review helpful to you?